What is the bit length and expression form of a MAC address? A. 24 bits expressed as a decimal number B. 24 bits expressed as a hexadecimal number C. 36 bits expressed as a binary number D. 48 bits expressed as a decimal number E. 48 bits expressed as a hexadecimal number

2 Answers  

---

Can u convert an ethernet port to a serial port (or) vice versa ?

2 Answers   ADP,

---

Which IP packet field will prevent endless loops? type-of-service identificationf lags time-to-live header checksum

1 Answers  

---

Identify the purpose of ICMP? A.) Avoiding routing loops B.) Send error and control messages C.) Transporting routing updates D.) Collision detection

2 Answers   Hughes,

---

Difference between Distance vector, Link state protocols

3 Answers   HCL,

---

---

Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp

4 Answers  

---

What is difference between switch & hub?

0 Answers  

---

friends i have 3ree prob which is asked in ibm india in technical round 1 what is ftp(this was easy i had answered) 2 why we use ftp(i think it is a tough one) 3 how can we enable ftp in the widows xp. friend i need these question answer as soon as possible if it is possible to reply within the eveing then i always obeyliged to you i am espacily looking towards the jitendera sinha who make most of the valuable answer loking toward you nidhi mall

3 Answers   IBM,

---

CPE is an acronym for which of the following? A.) Customer Premise Equipment B.) Central Processing Engineering C.) Customer Process Equipment D.) Central Processing Equipment

2 Answers   Cisco,

---

Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 Answers  

---

Identify 2 HDLC characteristics? A.) Default serial encapsulation B.) Open standard C.) Supports Stacker compression D.) Supports point-to-point and multipoint

3 Answers  

---

When you cords an IP address on a place router which command stale the IP processing on the interface? A. ip enable B. network ip-address C. ip address ip-address subnet mask D. the exit command from the enabled configuration E. copy running-configuration to startup-configuration

3 Answers  

---