Answer / omar aziz

An ideal infitite bus is a bus which is capable of
supplying an infinite current to the fault. It is a
theoratical concept to make sure that your maximum fault
currents are not limited by anything- worst case situation.

Im designing APFCR Panel for 600 KVAR.I need to calculate the full current so that i can choose the capacity of isolator/Breaker.Kindly suggest with formula.

1 Answers  

---

When to use Oil Transformer type and When to use Dry type? What is the difference between both?

2 Answers   ABC,

---

how does this job compare with others you have aplied for?

0 Answers  

---

What is power transformer?

3 Answers   Welspun,

---

how we can produce negative DC voltage ? please explain it .,thank u

1 Answers  

---

What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?

0 Answers   Limton,

---

What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??

0 Answers   Emerson,

---

I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE

0 Answers  

---

difine electrical ballast in HPSVL

0 Answers  

---

where was current transformer protection units used and why??

0 Answers  

---

WHAT IS FORMULA TO KNOW TO BACKUP TIME OF POWER PLANT 48V/50AMP DELTA POWER PLANT

1 Answers  

---

To test Transformer we give HT side 440V to see wheather that it is producing 17.6V on LT to verify Voltage ratio is correct or not but when we give the 440V voltage to LT side then what will happen to HT voltage ?

3 Answers   Aditya Birla,

---