Answer / kushal

knocking will occur

Answer / manjunatha reddy t

petrol pour in diesel engine,engine will run and high knock
occurs,because of petrol have less fire point than
diesel,then its burn quickly.this is called knocking. when u
pour diesel in petrol engine then engine will not going to
start

Answer / prasath.s

first it does not crank because of difference in compression
ratio and it does not have spark plug

Answer / kuldeep kundu

The Self Ignition temp of Petrol is high than diesel so if
we pour petrol into diesel engine the petrol can not ignit
and engine will not Start.

Answer / jaya

First the engine will not run...probably due to the above
reasons

Answer / vishal

engine is not start bcoz it can not reach ignition
temperatue of petrol

Answer / venkata satish

if petrol is injected in diesel engine, it will not burn b'cause it needs high temperatures and pressure (heat). diesel has low autoignition temperatures. so engine is neither going to genrate power nor runs.

Answer / kishan

knocking will occur

Answer / mohammad sohail

the following machine will not run at all bcoz after the
purification of petrol the disiel is liberated after then
the petrol is formed , and if we pour it altogether then
petrol will float on diesel bcoz of low density of
petrol.thats why machine will not work properly.

Answer / divyesh

DUE TO PETROL HAVE LOW DENSITY,SO DIESEL WILL FLOAT OVER
PETROL.ENGINE WILL START BUT DUE TO LOW IGNITION TEMP. OF
PETROL........

Tell the octane number in India???

9 Answers   TATA,

what is the function of platern water wall in a boiler? and difference between with ordinary water wall?

0 Answers  

Categories >> Engineering >> Mechanical Engineering Suggest New Category Question Asked @ Answers Views select what is advantage of hllow shaft over solid shaft aprt from material saving? does hollow shaft absorb more vibration than solid shaft? 0 5 wat is the meaning of cop of wet suction and dry suction????? 1 171 What is the difference between an axle and a shaft? reply soon frnds........ 4 260 16 inch = 1 ______________? 2 124 What are the steps taken in troubleshooting of a machine e.g extruder ME 0 26 What is a seal? ME 3 133 what is the mean of b.tech? 3 167 what type of pump 2 63 what is differance between ball screw and lead screw ? Amtek 1 86 What is the units of surface tension and also dimensional formula? RRB 3 218 What is meant by cigarcone? RRB 3 120 I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons 0 24 why steam power plant is more popular than gas turbine plant? ME 3 304 what is EEE in thermodynamics????? ME 2 223 what is the practical use of ENTROPY? JSW 4 282

1 Answers  

Name the carpentry process?

0 Answers  

on which part of the flywheel energ will get be stored?

6 Answers   TATA, Themis, Wipro,

Contaminants of fuel oil

0 Answers  

how many type of engine?

4 Answers   College School Exams Tests, SSB,

How is a submarine able to submerge and surface?

0 Answers  

what is the meaning of rheostat in maximum and minimum position?

0 Answers  

Draw the flow of F.O. diagram from service tank to Main Engine?

0 Answers  

if there is 30% loss in cooling of an ic engine then to reduce that it is ok to supply 30% less fuel? why?

1 Answers  

For maximum capacity of compressor inlet temperature of air should be high, low, very high.

7 Answers   BEL,