On Cisco catalyst 5000 how would you set the second port on the
controller in the first slot to full duplex?
A.) Set port duplex 1/1 full
B.) Set port duplex 1/2 full
C.) Set port duplex 0/1 full
D.) Set port duplex 0/2 full
- 2 Answers
- 5105 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: B
The syntax is: set type duplex slot/port
| Is This Answer Correct ? | 0 Yes | 0 No |
Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay
What is the regional telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE
what is the difference between osi and tcp ?
Which type of Ethernet framing is used for TCP/IP and DECnet? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
What does -1 signify in an extended IPX access list? A. permit this host B. deny this host C. permit only this subnet D. any host or any network
At which layer of the OSI Reference Model do bridges operate? A.) Physcial B.) Session C.) Datalink D.) Transport E.) Network
Given the Novell IPX address 1aceb0b.0000.0c12.3456 which part is the network portion of the address? A.) 0000 B.) 1 C.) 3456 D.) 1ace E.) 0000.0c12.3456 F.) 1aceb0b
How do areas benefit a link state inter network?
Explain the benefits of vlan?
How can an Ethernet switch improve network performance? Choose three
How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets
what is flow control,.
CCNA 
