On Cisco catalyst 5000 how would you set the second port on the
controller in the first slot to full duplex?
A.) Set port duplex 1/1 full
B.) Set port duplex 1/2 full
C.) Set port duplex 0/1 full
D.) Set port duplex 0/2 full
- 2 Answers
- 5108 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
The syntax is: set type duplex slot/port
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
If line down and protocol also down; in this case which layer move problem?
What are 10base5 ethernet lans?
Hi Jitendera, Wat do u do..?? I mean r u working anywhere???? Basically where r u from??? If u don't hv any problem, u can say..?? Or else mail me mr.shahin07@gmail.com
Explain how an spf algorithm works?
Explain the types of resource sharing?
Explain isakmp ?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
Which dynamic type draw back is, if single link down, it removes its routing table?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
What is default packet size of ipv6?
How many ways to access router?
Explain the matric of eigrp protocol?
What is HDLC?
How many types of ends in wan?
Briefly explain the conversion steps in data encapsulation.
