Why is distributed processing useful?

0 Answers  

---

Which command sets IGRP as the routing protocol for autonomous system 100? A. Router(config)#igrp 100 B. Router(config)#network 100 C. Router(config)#router igrp 100 D. Router(config)#enable igrp 100

1 Answers  

---

Write the procedure for Router for configuring DHCP?

4 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup

1 Answers  

---

Novell NetWare has an Ethernet frame type called Ethernet_II. What is the matching Cisco command line keyword for this encapsulation method? A.) dix B.) sap C.) arpa D.) gns E.) snap F.) novell-ether

1 Answers  

---

How Bridge Protocol Data Unit detect looping in Network? How Bridge Protocol Data Unit work? explain?

1 Answers  

---

Tell me which protocol works only on cisco routers?

0 Answers  

---

Identify the IPX standard access-list number range? A.) 600 - 699 B.) 1000 - 1099 C.) 1 - 99 D.) 100 - 199 E.) 800 - 899

1 Answers  

---

Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'

3 Answers  

---

What does the term "attenuation" mean in data communication? 1 loss of signal strength as distance increases 2 time for a signal to reach its destination 3 leakage of signals from one cable pair to another 4 strengthening of a signal by a networking device

3 Answers  

---

What are the different IPX access lists?

0 Answers  

---