Hi Jitendera, I need ur suggestion. I completed my CCNA
certification & also hving some sort of real time
experience. Now i m planning to do CCNP. Little bit
confusion is that whether it wud be better for me to go for
CCNP ya CCNA (Security). As off my goal is to reach CCIE
(Security & Switching/Routing). So tell me some solution of
my confusion yaar..!!!
Thanx & Regards
Shahin..
- 1 Answers
- 3637 Views
- I also Faced
- E-Mail Answers
Answer / jitendera kumar sinha
hi sahin at firstly congrats to get your ccna certification.
ok the question you ask is all dependent on your area of interest ccnp is good (only read it)but if want to come in security come on cspfa from there u can achive your goal,i am doing same thing.i have also completed ccna and i was also in gr8 confusion what to do next i ask lots of people and they ask to do that so i am forwarding this consept to you,and one thing if you are a b.tech graduate then cspfa is nessery.thats all about that. i think i increase your confusion .for ccie ccnp help so donot waste your money make a deep study and practice on simulator and be prepair for cspfa.thanks
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the need og jitu(config)#ip helper address <ip address> can any one exaplain it briefly specially shain i am looking towards you.Becoz you are the only one who can solve my that problem not even jitendera sinha
Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP
How does inter- VLAN communication take place? A. It takes place through any Cisco router B. It takes place through a Cisco router that can run ISL C. It takes place through a router but this disables all the router a security and filtering functionality for the VLANS D. For nonroutable protocals (e.g. NetBeui) the router provides communications between VLAN domains E. Inter-VLAN communication is not possible because each VLAN is a separate broadcast domain
What is the link state routing protocol in the TCP/IP protocol stack? A. IP B. IS-IS C. NLSP D. OSPF E. RIP version 2
What is a disadvantage of using a connection oriented protocal such as TCP? A. Packet acknowledgement may add overhead B. packets are not tagged with sequence numbers C. Loss or duplication of data packets is more likely to occur D. The application layer must assume responsibility for correct searchers of the data packets
What are the conversion steps of data encapsulation?
What is the difference between half duplex and full duplex?
Identify 2 characteristics of PPP? A.) Uses LLC to establish the link B.) Default serial encapsulation C.) Support multiple layer 3 protocols D.) Offers two types of authentication; PAP and CHAP
What is icmp protocol?
Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup
Hi, Shahin Thanks a lot for providing me these sites. These links are really helpful for me. r u working somewhere please let me know
Which element is used to define the rate in bits per second that a Frame Relay switch agrees to transfer data? A. clock rate (CP) B. Committed Information Rate (CIR) C. Local Management Interface (LMI) D. data link connection identifier (DICI) E. Committed Rate Measurement Intercal (CRIMI)
CCNA 
