Answer / raghavendran.r

"Hipot" is short for high potential (high voltage). A hipot
test checks for "good isolation." You do a hipot test by
making sure no current will flow from one point to another
point. In some ways a hipot test is the opposite of a
continuity test.
Hipot testers usually connect one side of the supply to
safety ground (Earth ground). The other side of the supply
is connected to the conductor being hipoted. With the
supply connected like this there are two places a given
conductor can be connected: high voltage or ground.

how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.

0 Answers   Hindustan Unilever Limited,

---

before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water

0 Answers  

---

Is corona effect occurs in Induction motor. pl. justify the answer.

4 Answers   KPS,

---

Name the test signals used in control system

0 Answers  

---

How does a television work?

0 Answers   Siemens,

---

---

why transformer is giving some humming noise .....?

11 Answers   Electrotherm, JSW,

---

what is the differnce b/w voltage and current

8 Answers   Steel Plant,

---

what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing

0 Answers   ABB, Genpect,

---

what is the function of anti-pumping in circuit breaker?

20 Answers   Aditya Birla, INEL, NCC,

---

Hai I have 2500KVA,Transformer,13.8KV/380.DELTA/STAR.How much load that I can take interms of current?How can I calculate also when I have loads in KW?

10 Answers   L&T,

---

what happen if the parallel generator phase angle shift by 1 degree in manual mode

0 Answers   EEEC, MEC,

---

i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.

0 Answers   SCM,

---