what are different types of excitation in synchronous
generator,what is the difference between them
Answers were Sorted based on User's Feedback
Answer / sohail
Normally D.C excitation is used for exciting the field wdg
of generator. A.C excitation is also used but through
rectifier and supplied through brushes and sliprings.
Nowadays brushless exciter with field ckt on stator and
armature on rotor with rectifiers are used, directly
connected to the field wdg ,eliminating the use of brushes.
| Is This Answer Correct ? | 27 Yes | 5 No |
Answer / qasim ali
there are two types of exitation:
rotary
static
rotary:in it , dc generator is used for excitition, that have the combination of sliprings n carbon brushed,this generator has a moving rotor n static stator..sliprings converts the axial motion of current to radial,and then dc frm this generator is given to poles of ac generator..
static:
here ac supply is taken from reserve power distribution center(rpdc) i.e frm 11kv or smthng else trnsmissin lines n then it is stepdown 400v by excitation trnsfrmr n then this ac passes through rectifier bridge .and then it goes to poles of ac genrator....
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / lashari
In the small Generators the batteries are used for excitation while in big generators the excitor in built in machine on the rotor of generator which is dc small generator to provide excitation current. so there are two types of excitation i) seperately excited and self excited discussed later..
www.bestarticlez.com
| Is This Answer Correct ? | 2 Yes | 8 No |
how to check three phase motor torque value?
Is there any standard guidelines/Criteria to design NGR/NGT.?
whether choke act as a voltage regulator in tubelight or not?
what is deferens between HT< DG
why only dc is given as excitation...why not ac???
What are the procedures followed for underground cable laying.....???
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
why ct ,cvt should be stored in a vertical position?
what are the advantages of having high voltage in transmission lines?
why using 3 phase
what is active power and rective power and power factor
what are all the components required to assemble solar panel other than pv cell?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)