Answer / raghavendran.r

Ins. Resistance = Sys.Voltage + 1
so IR in thsi case will be = 11kV + 1
So IR = 12MOhm.

A thumb rule is that Per kV of Sys Voltage must have 1MOhm
of Insulation resistance.

what is reactive power?

2 Answers   Vestas,

---

what are earthing material

1 Answers  

---

How many percent of power are not being registered if we bypass one side of the meter base terminal using #8 cu wire on 1-phase kwhr meter. 

1 Answers  

---

need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.

0 Answers  

---

sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.

0 Answers  

---

Write down the classification of the transmission line?

1 Answers  

---

What is mean by vector group? For what purposes we doing vector group test in transformers?

2 Answers  

---

The advantage of free wheeling diode in a Full Ware rectifier is -reduces the harmonics -Supplies the voltage at negative vlotage

4 Answers   GNFC,

---

what will happen when choke in tube light circuit was not working???

7 Answers  

---

What are the three types of compensators?

0 Answers  

---

what is the power ratio between power in star and delta circuit?

3 Answers  

---

What is the approximate percentage of Si content in transformer core(CRGO-Cold Rolled Grain Oriented)? Why it is kept so low?

1 Answers  

---