Answer / guest

Answer:: A

Cisco uses host to specify 0.0.0.0. This tells the router to
check all.

Cisco uses any to specify 255.255.255.255. This tells the
router to

ignore all and permit any address to use an access list test.

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

4 Answers   TCP,

---

Explain what is overlaod?

0 Answers  

---

Identify 3 characteristics of a connection oriented protocol? A.) Path determination B.) Flow control C.) Acknowledgements D.) Uses hop count as metric E.) 3 step handshake

2 Answers  

---

Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route

2 Answers  

---

Which statement is true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not a the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth

1 Answers  

---

Using the TCP/IP protocol suite a message is sent from host A to a destination IP address on the same LAN. How does host A determine the destination of MAC address? A. It uses a proxy APP B. It uses APP requests C. It uses RARP requests D. It uses a router lookup table

1 Answers  

---

Define mac address?

0 Answers  

---

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Gandalf5 B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) SAP

2 Answers  

---

IPX traffic using different encapsulation types can go over the same data link A. true B. false

1 Answers  

---

Is it possible that in a switched network that any port of the switch can be infected with any kind of viruses that jamed and create more traffic in network which cause slow network performance?

8 Answers   HCL,

---

What key do you use to view the last command? A.) Ctrl+X B.) Ctrl+Z C.) Ctrl+E D.) Ctrl+P

1 Answers  

---

Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register

1 Answers  

---