What are 3 ways to provide login access to router? A.) Console B.) TFTP C.) Rlogin D.) Auxiliary Port E.) X Windows F.) Telnet

2 Answers  

---

what is frame relay.and how it is different from isdn

1 Answers   HCL,

---

Which protocol resolves an IP address to a MAC address? A.) DHCP B.) RARP C.) ARP D.) NBP E.) DNS

3 Answers  

---

Which network mask should you place on a Class C address to accommodate a user requirement for five networks with a maximum of 17 hosts on each networks A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248

7 Answers  

---

Identify the true statements about the following access list: Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23 Access-list 101 permit ip any any A.) This access list prevents the host 192.10.172.0 from telneting B.) This access list prevents any telnet traffic from subnet 192.10.172.0/24 C.) This access list filters some telnet access D.) This access list denies any telnet traffic to subnet 192.10.172.0/24 E.) This access list is invalid F.) The netmask on the this access list is reversed

1 Answers  

---

---

What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.

2 Answers  

---

what is vlan and how will you configure vlan on 3650 switch and how many valn can you create on that switch

3 Answers   Aptron, Volvo,

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Router# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers   ABC,

---

what is the difference between eigrp and ospf

6 Answers   IBM, Wipro,

---

wat is last assignable host address in 209.165.201.0/27 network?

7 Answers  

---

You want to set the console password to ralph. What would be the first command you need to execute from global configuration mode? A.) line console 0 B.) enable password ralph C.) login password ralph D.) set password= ralph E.) password ralph F.) login Ralph

1 Answers  

---

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

1 Answers  

---