1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Which layer defines the physical topology?

A.) Application

B.) Transport

C.) Network

D.) Data Link

E.) Physical

F.) Session

Question Posted / guest


Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.)..

Answer / guest

Answer: E

Is This Answer Correct ?    2 Yes 1 No

Post New Answer

More CCNA Interview Questions

Identify the 3 kinds of routes IGRP advertises? A.) Interior B.) Dynamic C.) System D.) Exterior

1 Answers  

What command do we give if router IOS is stuck?

0 Answers  

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

The maximum distance on a 10BaseT network from the hub to a workstation is which of the following? A.) 500 meters B.) 1000 meters C.) 100 meters D.) 1500 meters

1 Answers  

LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server

1 Answers  




Given the IPX address 4a.0002.1111.a999, what is the network ID and what is the node ID? A.) net 4a host 0002.1111.a999 B.) net a999 node 0002.1111 C.) net 0002.1111.a999 node 4a D.) net 0002.1111 node a999

1 Answers  

Identify 3 IP applications? A.) AURP B.) ARP C.) Telnet D.) SMTP E.) DNS F.) RARP

2 Answers  

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

2 Answers  

What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth

2 Answers   IBM,

Suppose we are having two router i.e. Router1 and Router 2 connected with each other on Serial Link,Router Network having ip 192.168.1.0/24. 1> which ip is used at router1 and router2 interface? 2>Which Command is used to assign ip to router1 and router2 interface?

1 Answers  

Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Autonomous system number E.) Link state

1 Answers  

How do you find the parameters that you can use with the SHOW command? A.) ? show B.) show ? C.) debug show D.) help E.) sh?

1 Answers  

For more CCNA Interview Questions Click Here
Categories