FOR CO/CO2/O2/NOX applications which of the following manufature is best? and

FOR CO/CO2/O2/NOX applications which of the following
manufature is best? and what is the basic principle of gas
analysers?
ABB/YOKOGAWA/EMERSON/SIEMENS/TELEDYNE/THERMOFISHER

Question Posted / joby

4 Answers
7842 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

FOR CO/CO2/O2/NOX applications which of the following manufature is best? and what is the basic pr..

Answer / sarath

You can go for Yokogowa. Its performing well.

Is This Answer Correct ?

2 Yes

0 No

FOR CO/CO2/O2/NOX applications which of the following manufature is best? and what is the basic pr..

Answer / surath

As per my working experience Yokogawa is best.

Is This Answer Correct ?

2 Yes

1 No

FOR CO/CO2/O2/NOX applications which of the following manufature is best? and what is the basic pr..

Answer / farooq

well i have experience for working on horiba and siemens
analyzers and i found siemens analyzer is better and
infrared light absorpion principle is being used

Is This Answer Correct ?

1 Yes

1 No

FOR CO/CO2/O2/NOX applications which of the following manufature is best? and what is the basic pr..

Answer / mpf

Unfortunatly that is bound more to the investor than to the
quality of the named...

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.

0 Answers CCIE,

I want to install analog type, flange mounted gas flow meter (line size - 2"), for CNG flow measurement.Kindly give some details of flowmeter or suppler name, available in India.

1 Answers

how can we measure the pressure in underground cooling water pipeline by using pressure transmitter?what about the tapping position?

2 Answers

what are the following documents comes under loopchecking

1 Answers Heisco,

What is an antisurge control system, how it works?

3 Answers

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

0 Answers SEWA, Sharjah Electricity and Water Authority SEWA,

What is loop checking ?

10 Answers Kharafi National, Petrofac, Samsung,

Explain operation of Haskel pump.

0 Answers CCIE,

I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.

0 Answers

What is the reason for not giving very High Proportional Gain Kp in PID Controller?

2 Answers ABB,

need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate

0 Answers

what are the diff. in servo and regulatory control?

0 Answers

For more Instrumentation Interview Questions Click Here