Interested to Buy Any Domain ? << Click Here >> for more details...
FOR CO/CO2/O2/NOX applications which of the following
manufature is best? and what is the basic principle of gas
analysers?
ABB/YOKOGAWA/EMERSON/SIEMENS/TELEDYNE/THERMOFISHER
- 4 Answers
- 7700 Views
- I also Faced
- E-Mail Answers
Answer Posted / farooq
well i have experience for working on horiba and siemens
analyzers and i found siemens analyzer is better and
infrared light absorpion principle is being used
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
please tel me the calibration of pneumatic controler.
is motorized valve closed when power shutoff?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
what is the difference between -24 : +24 & 0:24 and where it use?
Explain the burnout feature.
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
How to Calibrate Interface Level Troll in field
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
