Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?

0 Answers   Qatar Petroleums,

---

how to calibrate any tansmiter by loop or hart calibrator

2 Answers  

---

what are the steps to follow force a particular input or out put from ics triplex esd system?

1 Answers  

---

Ega interview going on for power plant. Which type of question will asked. For questions

0 Answers   EGA,

---

If I installed wrong directions orifice plate then what showing value d.p transmitter?

2 Answers   Forbes, STS,

---

---

what is compensation in engineering and what is temperature compensation?

1 Answers   Binani, Yokogawa,

---

Manipulation of dead wt. tester double piston type.

0 Answers   CCIE,

---

Is there any interfacing sofware to build communication between a PC and ER300P model L&T make trivector meter via RS485 port which is available in the meter and is there any data acquisition card available to store the acquired data from the meter into the system

12 Answers  

---

How much voltage we get between two wire of 4 to 20 ma output? Is this voltage up or down respectvice to 4 - 20 ma ?

9 Answers  

---

why 8bit microprocessor referred as 2^16?

2 Answers  

---

Speedtronic system .

0 Answers   CCIE,

---

In dissolution apparatus how did you calibrate the distance from end of paddle to bottom of the bowl?

1 Answers   Reddy Labs,

---