Which NetWare protocol works on layer 3--network layer--of
the OSI model?
A. IPX
B. NCP
C. SPX
D. NetBIOS
- 1 Answers
- 6714 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
IPX (Internetwork Packet Exchange) is a NetWare
network layer 3 protocol used for transferring information
on LANs.
| Is This Answer Correct ? | 1 Yes | 0 No |
what are the 3ree way for implementing vlan on cisco switches what is the layer hierarchy of the cisco what is the best place of implementing standard access list what is q stand for isdn these are the challanging question for me i am waiting for jitendera sinha answer(it is challenge for u i have seen lots of answer given by u )it is a challenge in the frendshipmode plz donot take other wise
Which three statements about common elements of the TCP/IP protocol stack are true? (Choose three) A. IP provides connectionless service and routing capabilities B. APP enables devices to locate the IP address of local devices C. UDP provides simple connectionless service without windowing or acknowledgments D. ICMP provides connection oriented management data to routers and Layer 3 switches E. TCP enables devices to send large quantities of data using windowing in a connection oriented manner
How we can see mac address from dos prompt?
Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Router# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes
Can anyone explain in details port fast, uplink fast & backbone fast features introduced by CISCO (The GOD FATHER of NETWORKING.... Hehehehehe).
which defined peer ip address an local subnet belong to crete? (Choose two)
Which two encapsulation names are correctly paired with the Cisco IOS encapsulation names? (Choose two) A. Ethernet_II-ARPA B. Ethernet_802.3-SAP C. Ethernet_802.2-LLC D. Ethernet_SNAP-SNAP
Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -
What are the steps of data encapsulation?
Hi -All Can you tell me About of NAt (Network Address Tranlator) bcoz i have no idea about this topics Such as local ip , global ip and all plz provide the deatil of this topics
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
What route entry will be assigned to dead or invalid route in case of RIP?
CCNA 
