Port selection is done at which layer of OSI reference model?????

4 Answers  

---

At which layer of the OSI Reference Model do bridges operate? A.) Physcial B.) Session C.) Datalink D.) Transport E.) Network

2 Answers  

---

Which line from a show spantree 1 command output indicates that virtual LAN 1 (VLAN1) is functioning properly? A. Root pod is FastEthernet 0/26 B. Port Ethernet 0/1 of VLAN1 is Forwarding C. Designated port is Ethernet 0/1, path cost 10 D. Designated root has priority 0 address 00D0 588F B600 E. VLAN1 is executing the IEEE compatible Spanning Tree Protocol

1 Answers  

---

Identify 2 characteristics of PPP? A.) Uses LLC to establish the link B.) Default serial encapsulation C.) Support multiple layer 3 protocols D.) Offers two types of authentication; PAP and CHAP

3 Answers  

---

Identify 3 methods not used to prevent routing loops? A.) Holddown timers B.) Sequence numbers C.) Triggered updates D.) Split horizon E.) Area hierarchies F.) Order of router startup

3 Answers   IIHT,

---

Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells

3 Answers  

---

What does the acronym ARP stand for? A.) Address Resolution Phase B.) ARP Resolution Protocol C.) Address Resolution Protocol D.) Address Recall Protocol

2 Answers  

---

What is the UDP datagram format? A. Source Port - 16 bits, Destination Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data B. Destination Port - 16 bits, Source Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data C. Source Port - 16 bits, Destination Port - 16 bits, Checksum - 16 Bits, Length - 16 bits, Data D. Source Port - 8 bits, Destination Port - 8 bits, Length -8 Bits, Checksum - 8 bits, Data

1 Answers  

---

What command do we give if router ios is stucked?

0 Answers  

---

Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'

1 Answers  

---

Significance of IP helper-address Command on SW? Is it necessary to put this command?

1 Answers   Accenture,

---

"arpa" is used by the Cisco IOS for which encapsulation types? A. Ethernet_II B. Ethernet_802.3 C. Ethernet_802.2 D. Ethernet_SNAP

3 Answers   Cisco, Reliance,

---