Which statement about the Committed Information Rate (CIP)
is true?
A. It is the rate in bits per second at which the Frame
Relay switch agrees to transfer data
B. It is the clock speed (pod speed) of the connection
(local loop) to the Frame Relay cloud
C. It is the maximum number of bits that switch can
transferduring any Committed Rate Measurement Interval
D. It is a signaling standard between the 3PE device and FP
switch. It is responsible for managing the connection and
maintaining status between the devices.
- 1 Answers
- 4358 Views
- I also Faced
- E-Mail Answers
Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
Explain the difference between switch & hub?
Explain how many broadcast domains are in switch?
What is the most common layer 2 device? A. Hub B. Bridge C. Switch D. Router
Mention what does data packets consist of?
Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?
What is name of ospf algo?
Explain what is eigrp?
What does the IPX maximum path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)
If there is only 2 host in bus topology is that possible collision accord?
What is the draw back of eigrp protocol?
CCNA 
