Terminal blocks is used for segregate the connections...
There is any principle for terminal block..?
No Answer is Posted For this Question
Be the First to Post Answer
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
Technical specification of a wind farm
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
how we can improove power factor?????????
Diff between Earthed & Unearthed cable ?
operation principle of a generator? Gss, Diesel and HFO which is better and why?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage.
Alternator couple to diesel engine why, Alternator couple to ac service motor with gear drive for 1500 rpm possible (yes or no) aim to low input power supply give to motor then high output power taken for alternator Please answer this question
what is the different between rms and average value
Why do we will ground the positive terminal in electrostatic precipitator
any body can give me idea or sketch of fuel(Diesel) level controller for genset.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)