Answer / gajendra

Cable glanding is method of fixing end point of cable
armored with SC & DC gland to Panel and its used for earting
panel to cable.

Answer / veer upendra

Cable Glanding is fixed any Arrmad cable end point after
that cable Gland fix through nut with electrical Panel.

What is a system?

0 Answers  

---

I have recently seen a transformer which had two primary terminals and was connected between two lines,i would like to know what kind of transformer is it?short discription about it,any advantages,purpose of usage of the same.............

8 Answers  

---

why dc did not flows to earth?

2 Answers  

---

purpose of breaker contact multiplication relay?

5 Answers   ABB,

---

How much difference can there be between HT & LT KWH unit consumption at the same load?

1 Answers   DLF,

---

why do we earth the tandelta point of a power transformer bushing?

1 Answers  

---

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

0 Answers  

---

How to select AC3 duty contactor for DOL & Star-Delta starters

1 Answers  

---

HOW TO CALCULATE THE CABLE SIZE FOR POWER CABLE, CONTROL CABLE AND INSTRUMENT CABLE

1 Answers   TurboTech,

---

why characteristics of overcurrent relay is time-->psm instead of time-->current?

0 Answers   ABB,

---

What Should be the rating of transformer used in 33KV substation?

3 Answers  

---

WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?

0 Answers  

---