what is the meaning of cable Glanding can you explain brifly?
- 2 Answers
- 15236 Views
- I also Faced
- E-Mail Answers
Answer Posted / gajendra
Cable glanding is method of fixing end point of cable
armored with SC & DC gland to Panel and its used for earting
panel to cable.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
explanation of mesh bus bars
why do we put a transformer on soak before loading it
What is the difference between security constraint unit commitment and security constraint optimal power flow?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
what is the excess air in furnace
Define stepper motor. What is the use of stepper motor?
what is the use of sdf?
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
draw the block diagram of fire alarm?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
how to failure indution motor insulation & how to improve heat in motor insulation
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
