Answer / astaklesh

It icreases the friction between the moving parts.
Engine`s efficiency will reduce.
over heating may occur due to friction between moving parts.

Answer / papesh kumar roul

due to reduce the
friction and heat
also.Beacuse when two
gearing parts
rotate ,it creates heat
and noise .for more
inquary call me
+918895360898(papesh)

Answer / manoj kumar roy

To lubricate the moving parts and minimize wear and thus prevent frication bearing and other parts.
It must be prevent rust,corri, and clean crank case comp.
It must be reduce noise,and its kept to parts cool.

1 hp how much watt?

8 Answers   Blue Star, Toyo Engineering,

---

Will a steel cable become longer if it is heated while under load? Explain

0 Answers  

---

who was the frist rail ladies driver

2 Answers   RRB,

---

1. What is fluid? 2. What is switch? What is its function?

2 Answers  

---

What is the cause of major loss in efficiency of an IC engine?

28 Answers   DRDO, TATA,

---

What is the difference between torque and moment?

2 Answers  

---

"In boiler, what does steam and smoke goes out to the funnel. What reason?"

0 Answers   ABC Inc, RRB, Siemens,

---

What are the methods of heat transferin boiler & condenser

2 Answers  

---

WHAT ARE EARTH MOVING M/CS? WHAT IS BATCHING PLANT? WHAT IS HYDRAULIC JUMP? WHAT IS TIPPER (EARTH MOVING M/C)?

0 Answers  

---

What is the first part which moves when we start the vehicle.

2 Answers   Patel Engineering,

---

what are your negative points?

3 Answers  

---

why r u using enjine oil inside of diesel generaters.what is the uses & why r using diesel by pass filter. plese kindly answer me sir..?

0 Answers   Cap Gemini,

---