Answer / bhoopendra

at that point
bending moment
change its sign.

Answer / ganesh kulkarni

point of contraflecture means the point where its sign
changes from +ve to -ve or -ve to +ve with respect to base
line.

Answer / mukesh biswas

The point,where the bending moment value is zero,that is known as CONTRAFLEXTURE point.INn this point the bending moment change it's sign means -ve to +ve or +ve to -ve.

Answer / ajay partap singh

point of contraflexure is a point where bending moment changes sign in bending moment diagram. On the one side of this point there is sagging and on other side there is hogging or vice versa. This helps to find out where reinforcement should be changed. As on one side sagging means tension is on lower side so reinforcement is on lower side and on other side hogging means tension on upper side so reinforcemrnt is on above side. So significance is that bending moment is in opposite directon hence position of reinforcement can be precisiley determined.

Answer / somesh mathur

Point of Contraflexure is simply the point where the bending moment diagram changes sign and as a result the radius of curvature changes sign. It has nothing to do with shear force at the point. At the point of contraflexure bending moment is zero but vice versa may not be true.

Answer / state

its the point where shear force changes its sign...at this point the bending moment is zero.....

Answer / mohammad aasif bhat

Point of contraflucture is a point where the value of bending
moment changes from positive to nagative and the value of shear
force is high.

Answer / meraj ahmad

point of contraflexure is a point where bending moment is zero(0) or bending moment changes its sign.

Answer / shankar

whenever change in bending moment sign negative to positive or positive to negative that point is called contraflexure.this point shear force is zero.

Answer / suresh baria

Point of Contraflecture is a point where bending moment &
shear force both are Zero

How to know proportions of cement, sand, aggregate in different types of grades like M5, M10, M20, M30?

6 Answers   NCC,

Calculate the maximum allowable speed on a horizontal curve of radius 350m if the maximum allowable values of the lateral coefficient of friction are 0.14 and the rate of superelevation is 0.08.

0 Answers  

hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft

0 Answers   SOM,

Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?

0 Answers  

how to calculate the amount of cement & sand required for plastering

0 Answers  

Mention different types of roof systems?

0 Answers  

How long does it take concrete to harden?

0 Answers  

what will be the total emoluments for deputy surveyor in APPSC in the payband of ( 9460-27600). please give me the detailed information step wise?

0 Answers   APPSC,

Is there any alternate for plastering

1 Answers  

say you are requsituoning cement to build masonry wall made of burnt clay bricks. how many 50 kgs cement bags will you requisition for 1:5 ratio mortar joint, if they masonry wall volume is 10 m3

1 Answers  

What is allowable limit of silt in river sand for concrete

3 Answers   UIPL,

What do you mean by tolerance factor of concrete ?

0 Answers