Answer / parth belani

current and potential transformers used in the industries
are mainly of two types. One, which are used for protection
purpose. sencond type is of those which are used for
measuring purpose. The difference between them is their
saturation limit of the transformer core. Those which are
used for protection purpose should have higher saturation
limits.

Answer / c.hari balakrishnan

Instrument transformers (potential & Current)used for
protection and metering purpose...Current transformers
which is used for protection is normally 5P20 class,
for differential protection i.e, PX class cts & Metering
0.2FS5 class Cts whose saturation value is very less...
For Voltage transformers 0.2 & 3P class for
metering,Protection...

Answer / sidharth

current and potential x'mer are use for busbar protection.
In CT protection current is step down to lower value and
measured and gives signal to relay and same concept is use
for PT.

what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks

0 Answers  

---

What is the formula to calculate the rating of a three phase air circuit breaker

0 Answers  

---

Pls any send the cable selection chart. at azeemk30@gmail.com

2 Answers  

---

What is Harmonic affects in power system. what is unit of harmonics and how to measure it. how much value should be in power system.

1 Answers  

---

give me applications of sequence bridges . (used in 3 phase un balanced systems)

0 Answers  

---

for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?

0 Answers   Power World,

---

we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)

0 Answers   Honda,

---

WHAT IS THE MEANING OF 'UPF'&'LPF'.... HOW CAN WE DEFINE IT? WHAT IS THE VALUE/RANGE OF EARTH WIRE RESISTANCE USED PARTICULARLY IN HOME....

2 Answers  

---

What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?

0 Answers   ITC Infotech,

---

what is an oscillator?

7 Answers  

---

pls someone send me sample question papers along with the key.thanks in advance

0 Answers   HPCL,

---

sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"

0 Answers  

---