Answer / sandeep bishla

Due to FORM Factor which is 1.11

Answer / vaijanath nirgude

bcoz rating of transmission line in rms value
& rms value = form factor*average value
form factor = 1.11

If ac voltage applied to the field of dc generrator the output of dc generator ?

1 Answers   SSC,

---

In more then 1 phase bulb will glow are not?if yes then how it will glow?

2 Answers  

---

what is laser diodes?

0 Answers  

---

A 40 kva transformer has a core loss of 400W and a full load copper loss of 800W. What is The proportion of full load at maxmimum efficiency?

1 Answers  

---

Why the ceiling fan rotates in clockwise direction and table fan rotates in anticlockwise direction.

3 Answers   Kirloskar, MPF, Wipro,

---

hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E

0 Answers   HPCL,

---

in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter

0 Answers   L&T,

---

I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.

0 Answers  

---

What is the use of insulation tester and how it is to be used.

2 Answers  

---

How to parallel a alternator without using synchro scope or lamp methods

1 Answers   Ofer,

---

Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?

2 Answers  

---

hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?

0 Answers  

---