why voltage ratings of xmission are in 11, 33,66kv and why
not 11.5 ,16,19 or any other
Answer Posted / sandeep bishla
Due to FORM Factor which is 1.11
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
A low wet bulb temperature indicates
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
why connecting surge unit in contactor coil
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
What is a copper loss or i2r loss pc?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?