Answer / bl meena

mag. current is tested to see whether all the 3 phases are
properly magnetised or not.If any phase is taking a higher
current then it could be said that in that phase some
conductors are short,So it's better that during this test
variac be used to apply the voltage,one should slowly
increse the voltage or just on-off the multimeter used to
see the quick response,if current is quickly incresing use
variac,to protect the multimeter.

When batteries are connected in series the voltage increases but the current remains unchanged, how can this be? When you consider ohm's law. i.e. If voltage increases, current increases, providing resistance remains the same.

10 Answers  

---

what you mean ct ratio? why use 400/5a,200/5a,150/5a ?

1 Answers  

---

How the Oil Surge Relay works? How it protect the OLTC?

3 Answers   JSL,

---

If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these

0 Answers  

---

at high temperature conductivity increases for conductor what will happen for long transmission when temperature is high?

1 Answers  

---

why contactors are used ...? is contactors and relays are same ...?

5 Answers  

---

what is the necessity of neutral in 3 phase system?

5 Answers  

---

specific gravity of a battery?

6 Answers  

---

in delta connection, why motor rotate in high speed compared to star connection?

2 Answers  

---

What is the universal motor?

0 Answers  

---

Advantage of earthing transformer

2 Answers   EID Parry,

---

How can you start-up the 40w tube lite with 230v AC/DC without using any choke/Coil?

2 Answers  

---