Interested to Buy Any Domain ? << Click Here >> for more details...
how to carry out Magnetizing Current Test on Distribution
transformer and what purpose we are doing this test.
- 1 Answers
- 11607 Views
- CPCL, I also Faced
- E-Mail Answers
Answer Posted / bl meena
mag. current is tested to see whether all the 3 phases are
properly magnetised or not.If any phase is taking a higher
current then it could be said that in that phase some
conductors are short,So it's better that during this test
variac be used to apply the voltage,one should slowly
increse the voltage or just on-off the multimeter used to
see the quick response,if current is quickly incresing use
variac,to protect the multimeter.
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
What is sink and source?
what is transformor oil gread
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
1.what is the reason for transformer and lightning arrester blast in 33kv system
why ht cable end termination don't have a gland?
What is meant by impedance? difference between high & low impedance ?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What are the two segments of nyquist contour.
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
how 650 volts creates? where is use?
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
What aturn on methods of scr?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
