Where do we adjust the setting of thermal over load relay &
how cal calulate.
Answer / k.prakashchandra
Over load relay is set at 110 to 120 % of full load current
| Is This Answer Correct ? | 2 Yes | 0 No |
what is self capacitance of inductor
what does a string of resistors in a series will do?
what is impedence in transformer
describe the fully control circuit diagram of ac drives
Draw SLD feeding from the SS up to distribution board of the load, calculate cable size, breaker sizes, and meter for the following case: Ground Floor: electric room, pump room, 5 shops, each is 15 KW First Floor: 5 shops, each is 15 KW Second Floor: showroom 30 KW Service Loads: water pump 3 KW (3ph) , fire pump 3 KW (3ph), and one DB service 12 KW (3ph).
What is the current flow in 230v ac supply ? What is the current flow in 415v Ac supply ?
explain remenance . differentiate high remenance type ct & low remenance type ct
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
what is the relevance of knee point voltage in protection and metering grade CT ? and basically what is knee point voltage ?
what is first pole to clear factor ?
What is the difference between Analogue Addressable Systems and intelligent Addressable Systems
i) in which cases should we go for neutral and where should we go for ground? ii) in domestic supply we are getting 230v a.c.and what is the amount of current?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)