Where do we adjust the setting of thermal over load relay &
how cal calulate.
- 1 Answers
- 3678 Views
- Hilton, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Over load relay is set at 110 to 120 % of full load current
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
How it can worked plc based electrical system And which type of software using.
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
how to find out 3 phase complex power in per unit in unbalanced system?
Is it possible to connect a safety device in to parallel?
work of choke in florocent tube circuit ?
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
DEAR SIR,I GOT THE CALL LETTER FROM RRB, SECUNDERABD AS A JE-II SO PLEASE PROVIDE ME SOME MODEL QUESTION AND ANSWER PAPERS AND LAST YEAR QUESTION PAPERS
What is the high series capacitance winding on high voltage power transformer ?
The loads are connected with phase and ground then why current flow as the loads ?
What current position are you holding in your current company?
Why GRR starts from 60% of motor speed why not less than 60%?
why HT armoured cable does not glanding
