a 20ph motor runnig a load with direct belts, can we use
10hp motor for the same load with the help of gear where
motor rpm 900 and load rpm 250
Answer / g.vidyasagar
We can't use 10HP motor, because there is no difference in
transmission whether we use Belts or gears.
Is This Answer Correct ? | 0 Yes | 1 No |
I need BHEL Engineer Trainee written test papers in Mechanical stream.
From a group of 7 men and 6 women, five persons are to be selected to form a committee so that at least 3 men are there on the committee. In how many ways can it be done? A. 564 B. 645 C. 735 D. 756 E. None of these
How will you measure the eccentricity of the turbine rotor during running
Which bearing is connecting to I.C engine shaft?
as started in the job offer notification, is our basic salary of 1lakh good for you if employed?
Suppose water is there in a pot. It is being heated continuously untill formation of superheated steam. What is the temperature profile of water?. What is the temperature profile of the pot?.Imagine pot is heated from bottom.
1 Answers Ashok Leyland, IGCAR, Videocon,
I have mechanical job experience. I am planing to get diploma with the basis of my experience. which institutes will do this in fast track mode.
Hello, I am PRAVEEN, working with start-up company as design, I don have any sap experience. but I wanted to join mm course in atos. Is it good change domain?
In some engines glycerine is used in place of water for cooling of engine. Why ?
what is mechanical
4 Answers Lotte Pakistan PTA, TATA,
A bearing is designated as 6205 , what is it’s bore diameter:
How to convert from HP to BHP or CC to Bhp please explain????????