If there is no problem with the electronic circuit and regulator then why the

If there is no problem with the electronic circuit and
regulator then why the motor start rotating at low value of
regulator with full speed both at laod and no load???
and if my judgement of circuit is wrong then what is your
openion?

Question Posted / deadman_eee

1 Answers
2676 Views
I also Faced
E-Mail Answers

If there is no problem with the electronic circuit and regulator then why the motor start rotating..

Answer / betonaloka

How much cement is used in each building block?

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?

0 Answers apspdcl,

Why VL is more than the Vc?

2 Answers

can u give me a brief idea about power line carrier communication ??

0 Answers

Why do power lines not short out when they fall into water?

0 Answers

What is inverse definite minimum time lag relay? Where is it use?

0 Answers TATA,

why the blede and jow of isoletor demage in substation?explan.

1 Answers

How does a system control centre in a utility plant gets the grid frequency of the electrical network (50 Hz or 60 Hz)by the SCADA system?