Answer / satish kumar dhiman

Electronics deals with small size component and flow of
electron is taken in consideration
In electrical big size component & current flow is taken in
consideration.

Answer / don devil

Electronics deals with semi-conductor devices.
Electrical deals with conducting devices

Answer / akshay

where ohm's law is not followed is electronics..and else is electrical...

NIT J

Answer / sonia

Electronics deals with low voltage equipments and
Electrical deals with high voltage equipments.

Answer / surbhi singh

electronics works at low power and high frequency whereas electrical works at high power and low frequency

Answer / p.srikanth

what is difference between flow of electron and flow of
current

Answer / srinivasan.l

system which has more controls on power supply to the end
system consider as electronics.
then the system which directly connected to power supply is
known as electrical s

in microcontroller why processor is used why not controller?

3 Answers   Infosys,

what is encoder? mechanical encoder?

2 Answers   HCL, TATA, Tata Communications,

I've an interview for post of Lecturer in a ece Department. Can anyone send me some possible questions that can be helpful for me???????

0 Answers  

What is the difference diac and triac?

0 Answers  

what is the relation between power and frequncy

3 Answers  

1 what is 5P00F METHOD IN 8085 MIC. PRO. 2 what is NEXT STATE FUNCTION SYNTHESIS 3 HOW THE MULTI LEVEL FAULT CAN BE DETECTED

0 Answers   Wipro,

what is modem

5 Answers   HCL,

what is BIAS current/ voltage?

4 Answers   DELL, HCL,

What are the commonly used filters?

0 Answers  

A Square matrix each of whose diagonal element is 1 and each of the non-diagonal element is zero is called

7 Answers  

When an RC driving point impedance function has zeros at s=-2 & s=-3,then admissible poles for the function would be? a)s=0;s=-6 b)s=0;s=-3 c)s=0;s=-1 d)s=-3;s=-4

3 Answers   BSNL, Jindal Steel and Power,

in adaptor circuit there is a transformer(it has four input & four output)which is used after rectifier .for what they are using this? they connect input between 1&4 and get output across 1&2 how it is possible?

1 Answers