Answer / shyamkr

its delta-star mode.

Answer / srinu

Delta-Y

Answer / manish

Delta-Star

In Delta Primary Winding the Line Voltage is same as the
Phase Voltage (Let V volts), the transformation ratio is
same for all configuration (Let V'/V) & in Star Secondary
Winding the Line Voltage is SQRT(3) times of Phase Voltage.

Thus if Input Voltage is V
Then Delta Primary Phase Voltage = V volts
After Transformation Star Secondary Phase Voltage = V'
Thus Star Line Voltage = v' x SQRT(3)

Leading power factor means what? what is the power factor value while in power factor is leading? is power factor greater than one? In some cases i heard pf 0.8 leading then what about 0.8 lagging?

1 Answers   Rockfort Engineering,

---

In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?

3 Answers  

---

why the NGR (neutral grounding resistor) always OFF during DG off?

0 Answers   Bhel,

---

how to calculate the neautral earthing conductor size for a 500kva dg set.

2 Answers  

---

in 3-phase transformer which type of transformet is used in output side?

6 Answers   Essar,

---

What is the minimum distance between taransformer (say 2000 kva)and its earth pit?

2 Answers   Bhel,

---

what will happen when power factor is leading in distribution of power?

10 Answers   AMET, JTO, Power Grid,

---

What is the difference between surge arrestor and surge capacitor?

2 Answers   Shreem Electric Ltd,

---

why the crow do not feel the current in overhead line when it sits on the wire??????

6 Answers  

---

Comparing to AC transmission, corona & R in DC transmission is……. a) lower b) higher c) same

3 Answers  

---

Why control of DC motor is simpler?

0 Answers   BARC,

---

if transmission voltage expressed as the multipple of form factor(1.11)........11,33,66,220 etc......then why madakkathara substation(kerala) voltage is 400kv..not 440.....?

2 Answers   KSEB,

---