How to determine earth fault level to set relay for a
normal distribution system of 11 kV , 100 A load????????
Answer / k.prakashchandra
EFR is usually set at 20 % of OCR.The earth fault current
is V/ Z of the line + ER value of the support.But you can
not expect this calculated earth fault current.
| Is This Answer Correct ? | 1 Yes | 1 No |
WHAT WILL HAPPEN WHEN THE MOTOR FREQUENCY INCREASED OVER THE RATED MOTOR RPM THROUGH DRIVE?
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
for measuring current and etc.,why we use value of 1.732 in three phase calculation. not in single phase.why
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
what is the method of electric earth for the protection of low voltage electric equipment
1 Answers MacLellan, Shiva Corporation, Siemens,
1. When do you use a VFD motor? 2. If the ceiling fan is on slow speed, does it consume less electricity? 3. If we want the fan to consume less electricity at low speed, what do we have to do? 4. What does “battery of 180 AMP HOUR” mean to you? 5. What does “battery of 180 AMP HOUR” mean to you? 6. If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
6 Answers Asian Power, Bhel, Focus, Focus Energy, L&T,
Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 phase power. Why would that happen?
what will happen when two dc motors are connected to each other and anyone of them rotated?
How we can change the direction of rotation of Induction motor? Prove it using graphical methods.
what is MFD value in capacitor?I have 201 Kva load & reactive power is 150 Kvar. so how it is calculated?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)