Answer / umashankar

send all INTERVIEW Unigraphics QUESTIONS&ANSWERS pdf file

Answer / arun

Refer the below link for various articles on unigrapics
interview questions with answers ( few are only questions)

http://productdesignfunda.com/productdesignresources/productdesigndevelopmentjobs/55-unigraphics-interview-questions-with-answers-part-2

http://productdesignfunda.com/productdesignresources/productdesigndevelopmentjobs/69-unigraphics-interview-questions-part-3

Just browse through the website - you will get plenty of
proe and UG interview questions and many more.

Answer / umashankar

what is partfamily and wavelink in unigraphics NX4

What is a mechanism?

0 Answers  

---

How the F.W.C. system of diesel engine circulate?

0 Answers   HPCL,

---

Why centrifugal pump is not called as a positive displacement type of pump?

0 Answers  

---

how can one check wheather a gear and pinion are properly aligned or not for both running and static condition?

3 Answers   NTPC, OCCL, Toyota,

---

what is the material of radiator sleeves or mesh?

0 Answers  

---

Explain working of a fourneyron turbine?

0 Answers   John Deere,

---

how many type of engine?

4 Answers   College School Exams Tests, SSB,

---

How does the steam work in a steam turbine?

0 Answers   ABC Inc, RRB, Siemens,

---

25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS

0 Answers   L&T,

---

9. State the difference between unilateral and bilateral tolerance

1 Answers   Amul,

---

Which of the following rivers does not form any delta at its mouth ?

0 Answers   RRB,

---

why so dangerous charging compressed gas in to oil compressor

1 Answers  

---