What happens when too much oil is injected in the working
cylinder
Answer / vikas
When too much oil is injected into the cylinder then
phenomenon of knocking takes place..due to time lag between
oil entry and its combustion.
Is This Answer Correct ? | 11 Yes | 2 No |
What is the significance of pressure angle in gears?
What is a radial-flow turbine?
what is the highest critical temprature of refrigerant?
why to work in oil industry
What happens if we interchange fuels in IC engine...
what is the thermodynamics?
what is BHP?
1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?
What is the difference between pipe and tube?
Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very thanksful.....srinivas_1704@yahoo.co.in
what is the exact heat treatment cycle of IS 4522 Gr6 to get the required properties?
difference between fasteners & sheet metal company