Answer / swarup das

1. The tolerance on depth of ISMC 150 Channels shall be +/-
2.5mm.
2. The tolerance on flange width of ISMC 150 Channel shall
be +/-2mm.

temperature after chilled water coil what it be called in HVAC system?

1 Answers   Lupin,

---

I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.

0 Answers  

---

what is meant by horse power(h.p)?

3 Answers  

---

A superconductor is a

4 Answers   Bhel,

---

what is vapaur lock? how it can b suppressed?

1 Answers   L&T,

---

---

What are the causes of damage to propellers?

0 Answers  

---

When we are calculating the heat load sheets,why we are not considering the heat developed from the blood in the human body.Also both men & women can't acess aircondition in same way..women feel too cool even at 22 degree,while men can overcome that.

0 Answers   DVC,

---

Compare Brayton and Otto cycle.

3 Answers   Bhel,

---

how 2 prepae for technical aptitude? suggest me any books r

0 Answers   Jindal,

---

How much should be the minimum and maximum suction and discharge pressure of screw chiller plant.

0 Answers  

---

What does dynamics of machines deals with ?

0 Answers   Godrej,

---

Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.

0 Answers  

---