what is meant by cbct elr?
Answers were Sorted based on User's Feedback
Answer / amarnath
CBCT is Core Balancing Current Transformer and ELR is Earth
Leakage Relay...
| Is This Answer Correct ? | 11 Yes | 0 No |
Answer / j. nagarajan
It should not be called as CBCT ELR. Actually this is an
Earth Leakage Relay sensing the leakage current through a CT
provided at Cable end called CBCT, to protect the incomer.
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / subhash sahu
ELR Earth Leakage Relays along with CBCT are used to detect
leakage current in the earhing. If the earthing is not
proper a small amount of current will appear (in the order
of mA). ELR will continuously monitor the leakage current
if it exceeds the set threshold an output electromechanical
relay (which is inside the ELR) will operate. The output
relay contact can be connected to circuit breakers /
contactor to isolate power supply or alarms.
CBCT Core Balance Current Transformers these will come in
different sizes. the core material will be either nickel or
alloy of nickel, copper wire will be wounded on the core
and properly insulated. The 3-phase line along with neutral
are passed in this core and secondary is connected to ELR.
Idealy the leakage current should be zero if any earth
leakage happen the leakage current will appear at CBCT
secondary it will be detected by ELR.
| Is This Answer Correct ? | 0 Yes | 0 No |
what is 2 phase motor?
Whats the difference between three phase and single phase?
If the 11 KV supply is fail. what will happened with it's breaker if it is supplay to the 11KV motor?
can you show me the components inside a air circuit breaker with connection diagram?
why capacitor offer reactance to alternating current?
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
which type of amplifiers are used in multimete?
what is effect of leading power facter on the system and billing
in 11kv/400v transformer when only one phase of 11kv supply fails what happens to sec voltage and why
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
while grounding the galvenized metallic structures is it necessary to remove the galvenization at the point of contact? Or other wise is the galvenizatio a good conductor?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)