15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
1580how to calculate differential current when we testing differential relay..suppose we have 1000kw generator,630amp VCB,what value we should put /inject so that relay trip the VCB? PLLZ justify ur comment
1575Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
1839Hello every one I am currently working in IT side but i have an offer to work under 'A' license holder and he says i can get c license what is the use of c license and what shall i do after getting it basically i am an electrical graduate please help me shall i leave this it job and work in electrical maintenance will i have a good future i am confused Thank You in Advance
1 2366Post New Electrical Engineering Questions
how to find the Motor,s insulation Power?
why chock were used in old tubelights but are not newest tubelights?
Why is tan-delta test and capacitor measurement done on alternator?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
Draw transformer phasor diagram.(full load,no load)
how much cable size required for 70 kilowatt load.
What is measurement?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
What is Negative Potential Bias
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
why US countries maintains 110v and 60HZ
What are the operation carried out in thermal power station?
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
what are the factors to be considered while design the breaker either HT or LT??