Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
2155how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
1991what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
L&T,
2668Post New Electrical Engineering Questions
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
What is minimum phase system?
Define norton equivalent circuit?
What is Plank's Law?
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
for what purpose the star point is done in ct
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
low frequency protection why recomend?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
Can you explain about TEE protection scheme?
what is the VA(Volt-amphere)? define with calculation?
What will happen if the voltage in my house drops from 220V to any lower voltage?
what is the current density of copper & alluminium.
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?