Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) Why are L-beams (cast monoloithic with slab)that usually occur at the slab edge, provided with overhangs?
1 4378thermal power plants in steam using inlet of turbine.inlet of turbine pressure and flow is same as boiler feedpump why not use direct to turbine?
6 13762
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
How many cum of 9.5mm stone in 1 ton ?
Are there any special considerations to be taken into account for combusting ammonia?
how we can calculate chiller required ampear?
How to control the Relative humidity in Air handling unit in Pharmaceutical company ,the AHU is comprised with DX system(Cooling coil) and dry heaters. We are facing the RH issue low side and higher side.
What is the composition of Cast Iron Grade:GG P70 ?
how many digree of freedom in four bar chain
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
I am a B Tech student n am very much interested in science n math.in which site i can find more concept regarding ECE?
what is threaded joints ,where present usage ?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
WHAT IS THE DIFFERENCE B/W LUBE OIL 20 W 40 AND 20 W 40 OIL.
i can access command prompt in my pc. when i type cmd in run,message comes-you are restricted.contact admin. why is it so? how can acces it by just logging in as a user and not as admin.?????
why zero sequence impedance measurement is not applicable for single phase GT
why constant pressure is consider for thermal diffusivity??