Answer / badhehm

work is extracted from the expanding high pressure gas, the expansion is approximated by an isentropic process (i.e., a constant entropy process)

QUANTUM CHEMISTRY AND CHEMICAL ENGINEERING - EXAMPLE 31.10 : There are 6 spin orbitals in p subshell in a ground state carbon atom. Only 2 electrons fill the p subshell. Number of different ways for n electrons to occupy the k spin orbitals are k! / [ (n!) (k-n)! ]. Find the number of different configurations of electrons to occupy the p subshell in a carbon atom.

1 Answers  

---

ENVIRONMENTAL ENGINEERING - QUESTION 22.3 : A well delivers 225 US-gallons per minute of water to a chemical plant during normal system operation. (a) Calculate its flowrate in the unit of mega US-gallon per day or MGD. (b) The following formula is written next to the chlorine feed point : (chlorine feed rate, lb / day) = (flowrate, MGD) X (dose, mg / L) x (8.34). If this formula is correct, then what should the chlorine feed rate to be in pounds per day (lb / day) if the desired dose is 2 mg / L. (c) Prove by calculations that the constant 8.34 in the formula next to the chlorine feed point is correct. Let 1 US-gallon = 3.78541 L and 1 mg = 0.0000022046 pound.

1 Answers  

---

Explain what are some common precipitating agents used to remove metals from aqueous waste streams?

0 Answers  

---

What does the catalystic converter on an automobile do?

3 Answers  

---

i want to knowwhat kind of questions in interview in adnoc?

0 Answers  

---

---

In DM plant, If pH in anion outlet is 7.2 and Mixed bed pH is 6.2, wat could be the reason.

8 Answers   Cipla, Jindal,

---

Explain how do you design a vapor-liquid separator or a flash drum?

0 Answers  

---

what is difference between urea and NPK fertiliser?

2 Answers  

---

What does capacitor load means? How does it connect?

0 Answers  

---

PROCESS DESIGN - EXAMPLE 21.3 : According to a heuristic of chemical engineering plant design, assume a pressure difference dP = 4 psi for each 10-ft rise in elevation. A pump is needed to pump liquid from a storage tank at a lower elevation to a heating tank at a higher elevation with the elevation difference of 60 ft. (a) Find the pressure loss due to such elevation. (b) If the required minimum inlet pressure to the heating tank is 9 psi, with 1 control valve is installed between pump and heating tank, what is the dP minimum required for the control valve and the entrance to the heating tank when the heuristic mentions that at least 10 psi is required for the control valve? (c) The pressure at the inlet of the pump is 8 psi and the flowrate of the liquid produces pressure head of 50 psi. What is the total pressure produced by the pump? (d) Assume a pipeline dP of 2 psi / 100 ft for liquid flow in a pipe according to heuristic, what is the approximate maximum length of the pipe in ft that can be installed between the pump and the heating tank?

1 Answers  

---

Need to design filter...Length and diamter of shell

1 Answers  

---

PLZ ANYONE SEND ME PLACEMENT PAPERS OF I.O.C.L MY ID---- gaurav.nitw.5609@gmailcom

0 Answers   IOCL,

---