Company XYZ has an employee that works out of the home. The employee runs big client server applications and must quickly transfer large files. The company wants the best cost/benefit on this connection. What would be the most practical solution? A. an ISDN Basic Rate Interface (BRI) connection to the user at home B. a dedicated T1 connection to the user at home C. a dedicated Frame Relay connection to the user at home. D. a standard 28.8 analog dialup connection to the user at home.

Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi

What is the bandwidth capacity of one ISDN B channel A. 64 kbps B. 128 kbps C. 512 kbps D. 1.54 mkbps

Which statement about the data link connection identifier (DLCI) is true? A. It is a number that identifies a local virtual circuit in a Frame Relay network B. It is a signaling standard between the CIDE device and the Frame Relay switch C. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay Cloud D. It is the Maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the Committed Information Rate (CIP)

Which three tasks are required to confound a dial on demand routing (DDR) Basic Rate Interface (BRI) connection? (Choose three) A. define static routes B. confound the abler information C. specify the interesting franc that can enable the link D. define a DDR password to exchange when the link comes up

Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface

Wipro,

Which command specifies a second subinterface on serial interface 0? A. interface s 0.2 point-to-point B. interface 2 s.0 point-to-point C. suberinterface 2.s 0 point-to-point D. interface s 0 sub 2 point-to-point E. interface s 0.1 point-to-point sub 2

Which command should you use to create an IP standard access list? A. access-list standard 172.16.4.13 B. access-list 1 deny 172.16.4.13 0.0.0.0 C. access-list 100 deny 172.16.4.13 0.0.0.0 D. access-list 198 deny 172.16.4.13 255.255.255.255

Which router command allows you to determine if an IP access list is enabled on a particular interface? A. Router# show ip interface B. Router> show access-list C. Router# show ip access-list D. Router> show interface ip access-list E. Route 1 P.O. box 198

Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list

jetking,

Which of these is the Private key? A. Bear B. Cave C. Indian D. Cowboy

Which statement should you use to deny FTP access (only) from network 210 93 105 0 to network 223 8 151 0? A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access list 1 permit any B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp access list 100 permit hp any any D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp access list 100 permit ip any any

Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction

On a network design project you determine that a new testing application requires multiple hosts. These hosts must be capable of sharing data between each host and an enterprise server at 10 Mobs bandwidth. Other divisions in the company use applications that require less than 2 Mobs bandwidth of the enterprise server. What is your most economical recommendation? A. That existing 10BaseT hubs be replaced with 1 00BaseT hubs to improve overall performance B. That a router can separate the testing application from the rest of the network, thus allowing the testing application more bandwidth. C. That a switch be installed, so that the enterprise server can be provided a 100 Mobs pod and each of the testing application hosts can be given dedicated 10 Mobs pods] D. That a bridge be placed between the enterprise server and all other users with the exception of the testing application

What does CCNA stand for? A. Cisco Certified Network Administrator B. Cisco Certified Network Associate C. Certified Circuitry in Networking Apprentice D. Calico Cats of North America