Answer / guest

Answer: E

What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface

1 Answers  

---

what is ip address?

3 Answers   HCL,

---

Explain what are the ranges of private ips?

0 Answers  

---

Which of the following are Distant Vector protocols? A.) IGRP B.) RIP C.) OSFP D.) EIGRP

1 Answers  

---

Which Distance Vector characteristic can help to speed up convergence? A.) Triggered Updates. B.) Split Horizon. C.) Poison Reverse. D.) Hold Down timers. E.) Inverse ARP.

1 Answers  

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

1 Answers  

---

Which command sets IGRP as the routing protocol for autonomous system 100? A. Router(config)#igrp 100 B. Router(config)#network 100 C. Router(config)#router igrp 100 D. Router(config)#enable igrp 100

1 Answers  

---

Which type of LAN segmentation device enables high speed data exchange? A. hub B. bridge C. switch D. repeater

3 Answers   Accenture, TCS,

---

how to troubleshoot when protocols is down and link is not getting up

7 Answers   HCL, Sify,

---

What is the virtual channel?

0 Answers  

---

What ISDN protocol specifies concepts, terminology, and services? A.) Q B.) S C.) I D.) E

1 Answers  

---

hi all.. can any one explain the complete topology of stp and rstp how it works . root swtch connects to a root port and then root port conenct to other switchs designated port. i was going thru his site http://www.cisco.com/en/US/tech/tk389/tk621/technologies_whi te_paper09186a0080094cfa.shtml in which DR also exist on root switch only which makes my understanding grim.I had a diff notion of stp all together. please post asap. and if possible refer a url so thst i can read it my self .. thanks

1 Answers  

---