"sap" is used by the Cisco IOS for which encapsulation types? A. Ethernet_802.2 B. Token-Ring C. FDDI_SNAP D. Ethernet_802.3 E. FDDI_802.2
1 4394Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
1 7063Which type of Ethernet framing is used for TCP/IP and DECnet? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
1 6240You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.
1 4983NetWare IPX addressing uses a network number and a node number. Which statements are true? A. The network address is administratively assigned and can be up to 16 hexadecimal digits long. B. The node address is always administratively assigned. C. The node address is usually the MAC address. D. If the MAC address is used as the node address, then IPX eliminates the use of ARP.
1 4447Which NetWare protocol works on layer 3--network layer--of the OSI model? A. IPX B. NCP C. SPX D. NetBIOS
1 6803As a system administrator, you want to debug igrp but are worried that the "debug IP igrp transaction" command will flood the console. What is the command that you should use? A. debug IP igrp event B. debug IP igrp-events C. debug IP igrp summary D. debug IP igrp events
1 6061What does the following series of commands accomplish? router igrp 71 network 10.0.0.0 router igrp 109 network 172.68.7.0 A. It isolates networks 10.0.0.0 and 172.68.7.0. B. It loads igrp for networks 109 and 71. C. It disables RIP. D. It disables all routing protocols.
1 5446In the command "router igrp 109" what does 109 signify? A. an autonomous system B. any network number which the router is attached to C. the allowable length of the routing table D. the network socket number
1 6872IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing
1 4281IGRP uses flash updates, poison reverse updates, holddown times, and split horizon. How often does it broadcast its routing table updates? A. 90 seconds B. 10 seconds C. 30 seconds D. 45 seconds
1 7303The command "show IP protocol" displays which information? A. routing timers B. network information C. contents of the IP routing table D. information about all known network and subnetworks
4 20722An autonomous system can only exist if all routers in that system meet which criteria? A. interconnected B. run the same routing protocol C. assigned same autonomous system number D. run IGRP only E. run RIP only
1 8068
What is poe (power over ethernet)?
How many types of data?
What is the difference between unicast, multicast, broadcast, and anycast?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Which decision called socket base?
Explain the benefits of vlan?
What do you understand by ‘protocol’ in networking?
How does RIP differ from IGRP?
Which mathematically form used inipv6?
Mention what is the difference between tcp and udp?
What cable called v.35?
Explain what is 5-4-3 rule?
What are the two types of transmission technology use in ccna?
What is a vlan?
Why is vlan used?