The command "show IP protocol" displays which information?
A. routing timers
B. network information
C. contents of the IP routing table
D. information about all known network and subnetworks
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A & B
"show IP protocol" displays routing timers and
network information. "show IP route" displays the routing
table with information about all known networks and
subnetworks.
| Is This Answer Correct ? | 30 Yes | 7 No |
Answer / george
To display the parameters and current state of the active
routing protocol process, use the show ip protocols command
in EXEC mode.
| Is This Answer Correct ? | 6 Yes | 0 No |
Name the different types of networks
Define the virtual channel?
Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical
Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco
What will you do if ur IOS in coorrupt/deleted/Wrong Type/No IOS image ?
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
Can you describe the Authentication Header (AH) Protocol?
Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup
An ISDN BRI circuit can be described as which of the following? A.) 3B channels B.) 2-64Kbps B channels and 1-16Kbps D channel C.) none of the above D.) 2-64Kbps B channels and 1-16Kbps C channel
Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP
If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2
Can you explain PAP?