IGRP uses flash updates, poison reverse updates, holddown
times, and split horizon. How often does it broadcast its
routing table updates?
A. 90 seconds
B. 10 seconds
C. 30 seconds
D. 45 seconds
You create the following standard access-list access-list 1 deny 1.1.1.1 access-list 1 deny 2.2.2.2 int e0 ip access-group 1 in Which of the following statements are true, with regard to traffic flowing into E0? A.) This will stop IP packets with a source address of 1.1.1.1 only. B.) This will stop all IP packets. C.) This is an invalid configuration. D.) This will stop no IP packets. E.) This will stop IP packets with a source address of 2.2.2.2 only. F.) This will stop IP packets with a source address of 1.1.1.1 and 2.2.2.2.
Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.
What route entry will be assigned to dead or invalid route in case of RIP?
Which two types of route table entries are used by a Layer 3 router to determine the appropriate path to destination? (Choose two) A. static route entry B. default route entry C. Dynamic route entry D. temporary route entry E. permanent route entry
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup
What is the administrative distance for IGRP? A.) 90 B.) 120 C.) 110 D.) 100
Explain the difference between named and extended acl?
Can we write any script for router to instruct that from where it will boots e.g. TFTP,FLASH...if yes what is it and how? 1 of my frnds says its possible...
When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A
what is unike ip address
Define the virtual path?
What is point-to-point protocol in ccna?