What is the difference between service and systemctl?

935

State all possible different index configurations a table can possibly have?

964

What is the block size in Hadoop?

400

Why do we use joins in sql?

935

What do you know about the transfection of primary cortical neurons?

1737

What is auth :: routes ();?

698

Does c# support parameterized properties?

913

How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.

1591

What does the term sorting refer to?

1028

how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?

2751

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

2210

What is the use of android os?

854

For sloping slabs or sloping beams why the tension steel from either side of ridge is taken into compression zone of other side?

2165

What about your strength and weaknesses?

2628

What is the value for tei 1st t1?

905